Wheel Bearing Puller Toyota Truck/SUV w/popular adapters 1984-2018

Description

American Made!
Toyota Axle Bearing Puller and Attachments
.
"(almost)Everything Kit"
This kit is intended for the repair shop or enthusiast who works on a variety of
Toyota models and generations.
Everything you need to work on Toyota Truck and SUV rear axle bearings from 1984 to 2018!
This kit enables you to remove and reinstall almost any bearing and ABS tone ring (reluctor).
Save nearly compared to purchased
separately
Bolts to the bearing flange and fits into a Harbor Freight, or similar, 20-ton hydraulic press.
Includes:
Puller Body - Can also be used as a bearing installer for 44mm-49mm bearings
Tone Ring Tool - new stronger design
Late Model Adapter Plate
Tacoma adapter Plate 2005-up
Accesories:
40mm Bearing Installation Tool
New: 44/48/49mm bearing installation tool for all sizes of unit bearings.
(This tool replaces the ring seen in the lower left hand corner of the main photo.)
90mm Bearing Seating Tool
4" X 4" X 3/8" Press Plate
The puller set will fit on any of the following Toyota vehicles:
4Runner, Tacoma*, Tundra, FJ, Hilux, T100
1984 to present.
These models all use unit bearings. Depending on how corroded onto the axle the bearing is, and how worn the bearing is, the outer race and housing may separate from the inner race while pressing. This will require the inner race to be cut off. This situation is not the fault of the tool and is not a valid reason for return of this item.
This tool can be made to work with the Sequoia, but you need to know what you're doing. There is actually a couple of other options for this vehicle now available, depending on your circumstances. Contact me before ordering.
Also, it will fit any
symmetrical
4-bolt circle
from 100mm to 130mm w
ith 10mm  or 12mm studs
The vehicles below all use the same ABS tone ring, which can be removed with the included tone ring tool:
TOYOTA
4RUNNER
1996-2002
TOYOTA
HILUX
2004-2012
TOYOTA
T100
1995-1998
TOYOTA
TACOMA
1995-2004
TOYOTA
TUNDRA
2000-2006
Note: The tone ring tool
does not
fit 2001-2007 Sequoia. The tone ring tool only fits those vehicles listed above.
This kit also includes a 40mm bearing driver. Use this with your puller to install 40mm bearings. It's tall enough that the bellcrank will clear the press bed. Features a view port so that you can easily see the press action.
Get it right the first time and save time!
This 40mm
installer
only works with the 40mm bearing and tone ring that is
separate
from the housing.
It is
not intended
for the larger unit bearings used on later generation vehicles.
Black, Red and Yellow Powder Coated.  Bearing installer is Clear coated
Includes general instructions. Also, check out this "how-to" video on YouTube by Timmy the Toolman:
https://youtu.be/R-c2x3F8DU4  (copy and paste)
Free Shipping in the USA, including P.R. and APO/FPO
Made in the USA!
Many imported unauthorized copies of my design, of questionable quality,
are now listed on this site.
Beware!
"Shipped from California" does NOT mean Made in the USA